Full Text Searchable PDF User Manual
CHAT
®
50
Personal Speaker Phone
Quick Start Guide
CONFIGURING THE CHAT 50 ............................................1
CONNECTING YOUR CHAT 50 .........................................2
C
onneCting
the
ChAt 50
to
A
PC ........................................ 2
CONFIGURING AND TESTING YOUR CHAT 50 ................3
ChAt 50 A
udio
C
onfigurAtion
............................................. 3
USING THE CHAT 50 ..........................................................4
ChAt 50 Led i
ndiCAtors
..................................................... 4
V
oLume
& m
ute
B
uttons
....................................................... 4
CHAT 50 SPECIFICATIONS AND REQUIREMENTS .........5
s
ystem
r
equirements
............................................................ 5
t
eChniCAL
s
PeCifiCAtions
....................................................... 5
usB..................................................................................... 5
L
oudsPeAker
......................................................................... 5
m
iCroPhone
(
s
) ...................................................................... 5
P
ower
.................................................................................. 5
Table of Contents
QUICK START GUIDE
1
CONFIGURING THE CHAT 50
The CHAT 50 can be used right out of the box and there’s no software to
download or install if it is to be used only with a PC.
If the CHAT 50 is to be used with any other device or if the CHAT 50
firmware requires updates, follow the instructions in the CHAT 50 User’s
Manual to setup and configure the CHAT 50.
The latest version of the software and CHAT 50 User’s Manual can be
found on the ClearOne Website at:
http://www.clearone.com/resources#uc_voice
Go to the CHAT 50/150 section and click the relevant links.
Follow the instructions in the manual to install and configure the CHAT 50
device.
CHAT 50
Group Speaker Phone
2
CONNECTING YOUR CHAT 50
The following describes how to connect your CHAT 50 to a PC.
The CHAT 50 can also be connected to a number of other devices. For
information on connecting the CHAT 150 to other devices, refer to the
CHAT 50 User’s Manual.
C
onneCting
the
ChAt 50
to
A
PC
Use the included USB 2.0 cable to connect the CHAT 50 to your PC
(Figure 1).
Figure 1
- Connecting to a PC
QUICK START GUIDE
3
CONFIGURING AND TESTING YOUR CHAT 50
Consult the CHAT 50 User’s Manual for all device and software
configuration procedures as needed.
ChAt 50 A
udio
C
onfigurAtion
To ensure optimal sound quality, the CHAT 50
MUST
be tuned properly
prior to use or after the device has been moved. The CHAT 50’s audio
settings must also be customized for the specific application it is to be
used with and for the specific device it is to be connected to.
The CHAT 50 derives its audio settings from the Windows sound settings
if it is attached to a PC or through the 3rd party application’s settings
(Skype, etc.) Refer to the tuning procedures in the
Optimizing Sound
Quality
section in the
CHAT 50 User’s Manual
or consult the specific
3rd party application’s tuning adjustments.
For further details on configuring various devices for the CHAT 50 audio
settings, refer to the
CHAT 50 User’s Manual
.
CHAT 50
Group Speaker Phone
4
USING THE CHAT 50
ChAt 50 Led i
ndiCAtors
The three microphone LED indicators illuminate blue when the CHAT 50
microphones are active. The indicators illuminate red when the micro-
phones are muted.
The seven volume LED indicators illuminate blue to indicate the current
volume setting—more lights indicate higher volume.
V
oLume
& m
ute
B
uttons
Use the
Volume Up/Down
buttons (indicated by a large dot and a small
dot) to adjust the volume level of the CHAT 50. Holding down either but-
ton will change the volume rapidly.
Use the
Mute
button to mute the CHAT 50’s microphone until the
Mute
button is pressed again. If you are using the CHAT 50 with a PC, you can
also use the Speaker Volume Control in Windows, as well as the CHAT
50 software to adjust the volume and mute the microphone.
QUICK START GUIDE
5
CHAT 50 SPECIFICATIONS AND REQUIREMENTS
s
ystem
r
equirements
Microsoft Windows XP SP2, Vista, 7 and 8 (All Versions)
t
eChniCAL
s
PeCifiCAtions
USB
USB 2.0 Compatible
USB Connector: Type B
USB Cable, Black
Loudspeaker
Bandwidth:
CHAT 50: 130Hz – 20kHz
Maximum Output Levels:
CHAT 50: 82dB SPL @ 1 meter
Microphone(s)
Bandwidth: 100Hz – 12kHz
Power
USB-powered: 5 VDC @ 500mA Maximum
Caution
: Read the Safety Information in
the instruction manual
Technical Support
U.S. PATENTS: D539,274; D556,189; D531,999.
OTHER PATENTS PENDING.
© 2014 ClearOne, Inc. All rights reserved.
Information in this document is subject to change without notice. 800-159-002 Revision 3.1 July 2014
TELEPHONE
1.800.283.5936
FAX
1.801.974.3669
tech.support@clearone.com
CHAT
®
50
个人会议扬声器
快速入门指南
配置
CHAT 50 .....................................................................1
连接您的
CHAT 50 ..............................................................2
将
CHAT 50
连接到
PC ...................................................... 2
配置和测试您的
CHAT 50 ...................................................3
CHAT 50
音频配置
............................................................. 3
使用
CHAT 50 .....................................................................4
CHAT 50 LED
指示灯
......................................................... 4
音量和静音按钮
................................................................. 4
CHAT 50
规格和要求
..........................................................5
系统要求
............................................................................ 5
技术规范
............................................................................ 5
USB .................................................................................... 5
扬声器
................................................................................ 5
麦克风
................................................................................ 5
电源
.................................................................................... 5
目录表
QUICK START GUIDE
1
配置
CHAT 50
CHAT 50
可以开箱即用。如果仅用于
PC
，不必下载或安装任何软件。
如果
CHAT 50
要与任何其他设备一起使用或是
CHAT 50
固件需要更
新，请按照
CHAT 50
用户手册中的说明来设置和配置
CHAT 50
。
CHAT 50
用户手册和最新版本软件可以在
ClearOne
公司网站上找到：
http://www.clearone.com/resources#uc_voice
找到
CHAT 50/150
的部分，并点击相关链接即可。
请按照手册中的说明来安装和配置
CHAT 50
设备。
QUICK START GUIDE
2
连接您的
CHAT 50
下面描述了如何将您的
CHAT 50
连接到
PC
上。
CHAT 50
还可以连接到许多其他设备。如想将
CHAT 150
连接到其他设
备，请参阅
CHAT 50
用户手册。
将
CHAT 50
连接到
PC
使用附带的
USB 2.0
电缆将
CHAT 50
连接到您的
PC
机上（见图
1
）。
图
1
-
连接到一台
PC
机
CHAT 50
Group Speaker Phone
3
配置和测试您的
CHAT 50
所有设备和软件所需的配置过程可查阅
CHAT 50
用户手册。
CHAT 50
音频配置
为了保证最佳的音质，
CHAT 50
必须
在使用之前或是在设备被移动之后
进行恰当的调整。
CHAT 50
的音频设置也必需要为使用的特定应用程序
或是连接的特定设备而定制。
如果
CHAT 50
是直接连接到一台
PC
或通过第三方应用程序（如
Skype
等）设置来连接，扬声器的音频设置便源于
Windows
的声音设置。请参
阅
CHAT 50
用户手册
中的
优化声音质量
章节或咨询具体的第三方应用程
序优化调整。
为了进一步了解如何配置各种设备来适应
CHAT 50
的音频设置，请参考
CHAT 50
用户手册
。
QUICK START GUIDE
4
使用
CHAT 50
CHAT 50 LED
指示灯
当
CHAT 50
的麦克风处于激活状态时，麦克风
LED
指示灯会亮起三个
蓝灯。当麦克风静音时，这些指标灯会亮起红灯。
七个音量
LED
指示灯亮起蓝灯时表明当前的音量设置，音量越高则亮的
灯越多。
音量和静音按钮
使用
音量升
/
降
按钮来调整
CHAT 50
的音量级别（按钮分别用一个大圆
点和一个小圆点来标识）。长按住按钮会迅速改变音量。
使用
静音
按钮可以使
CHAT 50
的麦克风静音，再次按
静音
按钮可取消
静音。如果您正在通过一台
PC
机使用
CHAT 50
，您可以使用
Windows
中的扬声器音量控制，也可以通过
CHAT 50
软件来调整音量和使麦克
风静音。
CHAT 50
Group Speaker Phone
5
CHAT 50
规格和要求
系统需求
Microsoft Windows XP SP2, Vista, 7
和
8
（所有版本）
技术规范
USB
USB 2.0
兼容
USB
连接器型号：
B
型
USB
线，黑色
扬声器
带宽：
CHAT 50: 130Hz – 20kHz
最大输出电平：
CHAT 50: 82dB SPL @ 1
米
麦克风
带宽：
100Hz – 12kHz
电源
USB
供电：
5 VDC
最大电流：
500mA
注意
：请阅读使用手册中的安全信息
技术支持
美国专利
: D539,274; D556,189; D531,999.
其他专利待批。
© 2014 ClearOne, Inc.
版权所有。
本文档中的信息如有更改，恕不另行通知。
800-159-002
版本
3.1
，
2014
年
7
月
电话
1.800.283.5936
传真
1.801.974.3669
电邮
tech.support@clearone.com