Full Text Searchable PDF User Manual
Operating Instructions for Electronic Classroom:
Corboy Law Center 711
For immediate assistance, please call ext. 8-4ITS
Hours of Operation: M-F 7am-9pm
•
Sat 8am-3pm
•
Sun Closed
**Please note that support hours are subject to change without formal posting.
Instructional Technology & Research Support (ITRS)
•
Revised 6/22/2012
The Electronic Classroom (EC) consists of three basic units: 1)
Ceiling
Projector
and
Remote Control
2)
Computer
and
Monitor
; and 3)
Equipment Rack
(shown below). Equipment rack includes: Main Power, Auxiliary
Plate, “Extron” MediaLink Switcher, Mixer, and VHS/DVD combo player.
To Turn On the Ceiling Projector:
1.
Locate the
remote control
(attached to the worktable).
2.
Point the remote at the ceiling projector and press softly, the
ON
button in the upper
right hand corner, a few times. You will hear the projector fan go on, and see a blue
light gradually glowing in the projector lens; this can take up to 1 minute.
To Turn On Equipment*:
The
Equipment Rack
is located inside the
cabinet
on or under the
table
.
1.
Make sure the blue Main Power switch (on the right), as shown below, is “ON”.
2.
To adjust the volume, turn the Volume Adjust knob on the Extron Switcher.
* The power buttons of all rack equipment should remain in the “ON” position.
**If you are using the
VHS/DVD
combo player, and it does not respond, check to see if the power was shut off
manually on the left side of the player.
To Project an Image from the Computer Workstation:
1.
Turn on the computer and monitor, if not already on, as you normally
would.
2.
Turn on the ceiling projector (see “To Turn on the Ceiling Projector”
Instructions above).
3.
On the remote control, press the
Input 1
button.
4.
Press input #4
PC
on the Extron Switcher. #4 PC
To Login to a Workstation:
Input (1, 2, 3, 4)
buttons
Input 1 button
Volume Control
Main Power
Extron Switcher
VHS/DVD
ON button
For immediate assistance, please call ext. 8-4ITS
Hours of Operation: M-F 7am-9pm
•
Sat 8am-3pm
•
Sun Closed
**Please note that support hours are subject to change without formal posting.
Instructional Technology & Research Support (ITRS)
•
Revised 6/22/2012
This workstation has been upgraded to
Windows 7
and
Office 2010
as part of Loyola's Microsoft Migration Project. Upgrades to
all campus lab computers are scheduled for the 2011 summer break. Faculty and staff computers will be upgraded during the fall
2011 semester. Information about the upgrade project is available online at
www.luc.edu/windows7.
Questions or comments
can be directed via email to
windows7@luc.edu
.
1.
At the prompt, hit the Ctrl+Alt+Del keys on the keyboard
2.
Type your Username and Password and click the blue arrow button.
To Use your Laptop Computer in the Classroom:
1.
Turn on the ceiling projector (see “To Turn on the Ceiling Projector” Instructions).
2.
Connect the laptop’s
VGA
output and
audio
ports to the “LAPTOP INPUTS” on
the
Aux Plate
.
3.
On the remote control, press the
Input 1
button.
4.
Press input #5 Laptop
on the Extron Switcher.
5.
Turn on the power to your laptop. There is a convenience plug located near the top of the rack.
6.
If you don’t see the laptop’s image on the screen, toggle the
Laptop’s
Function LCD/CRT (Display)
button.
Projecting a VHS tape:
1.
Turn on ceiling projector (see “To Turn on the Ceiling Projector” Instructions).
2.
On the Extron Switcher, press input
#1
VCR/DVD
button.
3.
On the projector remote control, press the
INPUT 3
button.
4.
Insert your tape, and press play.
Please Power Down the Projector Before You Leave the Room
System Shutdown:
Point the remote at the ceiling projector and press the
OFF
button, in the upper right corner,
TWICE
.
You should see the blue glow within the lens shutoff and the screen goes dark.
NOTE:
The fan remains on even though the projector is off.
Input 1 button
Input 3 button
OFF button
Convenience plug
Extron Switcher:
#5 LAPTOP
Aux Plate:
LAPTOP INPUTS
Extron Switcher:
#1 VCR/DVD
VHS/DVD Player
Volume Control