Full Text Searchable PDF User Manual
TPFA 70
7” Digital Picture Frame
User Guide
IMPORTANT SAFETY INFORMATION
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with a slightly damp lint free cloth.
Do not block any ventilation openings.
Install in accordance with the manufacturer’s
instructions.
Do not install or operate near any heat sources such as
radiators, stoves, or other apparatus that produce heat.
Unplug this apparatus during lightning storms or
when unused for long periods of time.
Refer all servicing to qualifi ed service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as the power-supply
cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not
operate normally, or has been dropped.
Warning:
To reduce the risk of fi re or electrical
shock, do not expose this product to rain or moisture.
The product must not be exposed to dripping and
splashing and no object fi lled with liquids such as a
vase of fl owers should be placed on the product.
No naked fl ame sources such as candles should be
placed on the product.
Caution:
Changes or modifi cations not expressly
approved by the manufacturer could void the user’s
authority to operate this device.
Caution:
Usage of controls or adjustments or
performance of procedures other than those
specifi ed herein may result in hazardous exposure.
IMPORTANT
Use this appliance with the supplied AC convertor. Using
non-approved power supplies will void the warranty.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communication. However, this
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit diff erent from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
This symbol indicates that there are important operating and
maintenance instructions in the literature accompanying this unit.
This symbol indicates that dangerous voltage constituting
a risk of electric shock is present within this unit.
Page 2
INTRODUCTION
Your Digital Picture Frame (DPF) enables you to view digital pictures
from either a memory card or from a USB drive.
The DPF is compatible with the following card formats: SD™ (Secure
Disk), MMC™(Multimedia Card), and MS™ (Memory Stick).
The Frame will also support a USB 2.0 or 1.1 drive.
PICTURE FORMATS
The DPF will play pictures conforming to the .jpg (jpeg) standard. Other
picture formats must be converted to jpgs via photo editing software
(not supplied).
FILES AND FOLDERS
You may have your pictures grouped into Albums (folders) with several
pictures inside each album. The DPF will read the pictures and play
them in sets but you cannot identify or select individual folders.
The DPF will take time to load and display pictures. Lots of high
resolution pictures will slow loading times considerably.
UNPACKING
The box should contain:
• The Picture Frame
• External Power Adapter
• Stand
• User Guide
If any items are missing or damaged, contact your nearest TESCO store
for a replacement. Have your receipt ready when you call. Retain the
packaging. If you dispose of it, do so having regard to any recycling
regulations in your area.
Before using the Picture Frame carefully remove any protective
fi lm covering the screen. Take care not to press on the screen.
Page 3
Page 4
FITTING THE STAND
Locate the stand in the slot at the rear.
Rotate the stand once to put the frame into horizontal (landscape) view.
Rotate once more to put the frame into vertical (portrait) view.
Stand the frame on a level solid surface where it is unlikely to fall or get
knocked over.
WALL MOUNTING
As an alternative the frame can be wall mounted via the slots in the rear
of the frame.
?
Use the two holes annotated
q
(78mm apart) to mount the DPF in the
horizontal (landscape) view.
Use the two holes annotated
w
(78mm apart) to mount the DPF in the
vertical (portrait) view.
q
w
CONTROLS AND FUNCTIONS
1 SD/MMC/MS-card slot
2 USB
slot
3 5V DC Input socket
4 [
] Right/Next button
5 [
] Up button; Back to preview while
playing a slideshow
6 [
] Previous/Left button
7 [
] Down button; Rotate photo
while playing a slideshow
8 [
X
] Play/Pause; Confi rm/Enter; hold to
enter main menu
9 On/Off switch
10 Stand
Page 5
q
r
t
i y
w
u
1)
o
e
Page 6
GETTING STARTED
CONNECTING THE POWER SUPPLY
Plug the DC power jack of the adapter into the DC socket in the DPF.
Plug the power adapter into the mains socket. Switch on at the mains.
Switch the ON /OFF switch to the ON position.
If the DPF is being switched on for the fi rst time, or after a default
setting reset, you must fi rst select a display language. Use the
(
) or (
) buttons to make your selection and press the (
f
)
button to confi rm.
Page 7
INSTALLING A USB DEVICE OR MEMORY CARD
To insert a memory card
.
Position the card with the cropped corner
facing down and press gently in.
To release a memory card
.
Grip both sides of the card and gently pull
out.
When fi rst switched on the pictures will display as a Slide Show.
Thereafter the display will depend on the setup you have customised.
NOTES:
You should only insert one media source at any time.
•
If you switch on the DPF with a USB drive and a memory card
inserted in the frame, the memory card photos will be displayed.
•
If you have a USB drive inserted then insert a media card the DPF
will play the media card and vice versa.
Page 8
VIEWING PHOTOS
Main menu
In the main menu, you can select the connected memory device to view
photos, change frame settings, or play the photos immediately.
1 When pictures are being displayed press and hold the (
f
) button
to access the main menu. In this menu Connected sources (USB or
Card), “Setup” and “Now Playing” icons are displayed.
USB
Highlighted when you select a USB fl ash drive.
SD/MMC/MS
Highlighted when you select a SD/MMC/MS card.
Setup
Allows you to customize the settings of the DPF.
Now Playing
Allows you to play a slideshow immediately.
2 Use the (
) or (
) buttons to navigate between the options
in the main menu. Press the (
f
) button to confi rm or enter the
selected submenu.
NOTES:
While in the main menu, if you insert a SD/MMC/MS card or a USB
•
device, the DPF will start a slideshow automatically.
There is a button indicator on the right of the screen, indicating
•
which button you are pressing.
Playing a slideshow
There are two ways of playing a slideshow:
1 Press the (
) or (
) buttons to select a memory device (USB
or SD/MMC/MS card) in the main menu, and then press the (
f
)
button. The DPF will start a slideshow from the memory device
connected.
2 Press the (
) or (
) buttons to select Now Playing in the
main menu, and then press the (
f
) button. The DPF will start a
slideshow from the memory device connected..
When you enter the slideshow mode, the following menu is
•
temporarily shown on the bottom of the screen:
Press the (
•
) button to see a preview of all the photos in the
folder (refer to Viewing thumbnails on page 10).
Use the (
•
) or (
) button to move to the previous or next
photo.
To rotate a photo, press the (
•
) button, the options are:
once = 90°
twice = 180°
three times = 270°.
NOTE:
If there are memory devices inserted in the DPF before it is
•
switched on, the frame will automatically start to play a slideshow.
Using the OSD menu
You can use the OSD menu to manually view the photos one by one.
1 Press the (
f
) button during viewing a photo or slideshow. The
OSD menu appears on the screen and slideshow pauses.
The following menu will also be shown:
2 Press the (
) or (
) button to navigate between the icons on
the OSD menu.
To start or resume slide show from the current photo, highlight
•
(
f
) and press the (
f
) button. The (
f
) icon is changed to (
ll
)
icon or vice versa.
To skip to previous or next photo, highlight (
•
) or ( ), and then
press the (
f
) button.
Page 9
Page 10
To rotate a photo, highlight (
•
) and press the (
f
) button
repeatedly.
To return to thumbnail mode, highlight (
•
) and press the (
f
)
button.
To zoom in a photo, highlight
•
and press the (
f
) button
repeatedly, the options are: X2, X4, X8 and X16.
Viewing thumbnails
1 While playing a slideshow or viewing a single photo, you can use
the (
) button to enter preview (thumbnail mode). Up to 12
photos are displayed at a time.
2 To navigate through the thumbnails or move to the next or
previous page of thumbnails, press the (
), (
), (
) or
(
) button.
3 To view a selected thumbnail, press the (
f
) button.
Note:
Hold the (
•
f
) button to return to the main menu.
Changing Frame Settings
The system settings let you customise and confi gure your Digital Picture
Frame.
1. Select
the
Setup
icon in the main menu and press the (
f
)
button.
The Setup Menu appears on the screen.
2. To select a setting option, press the (
) or (
) button.
3. To alter the option, press the (
f
) button. Then, press the
(
), (
) button to select the new setting. Press the (
f
)
button to confi rm.
4. Press and hold the (
f
) button to return to the main menu.
Page 11
Setting items
Setting Items
Description
Language
Set the display language of the DPF.
Slideshow Time
Set the interval time for slideshow
The available options are: 3s, 5s, 15s, 1 min,
15mins, 1 hour.
Slideshow shuffl e
To play photos in a random order or in order
while playing a slideshow.
Transition Eff ect
Set the style of transition.
The available options are: , None, Bottom
To Top, Top To Bottom, Left To Right, Right
To Left, Close Door, Open Door, Horiz. Cross,
Vert. Cross, Random, Fading, Vexpand Top,
Vexpand Bottom, Vexpand Middle.
Now Playing
To play a slideshow immediately.
Brightness
Adjust the brightness of the screen
Contrast
Adjust the contrast of the screen.
Saturation
Adjust the saturation of the screen.
Setting Items
Description
Hint time
Set how long to display the button
operation window while in slideshow
mode. The available options are: 0s, 5s,
15s, 20s.
Photo mode
Set photos to Full mode or Standard mode
when you are viewing them.
Default settings
Reset all settings to the default settings.
Tesco Stores Ltd, Delamare Road, Cheshunt, Herts, EN8 9SL
A
fter Use
Switch the set off via the POWER switch.
Unplug the adaptor from the mains and then
unplug the adaptor from the DPF.
Unplug any memory card or USB stick.
Store the unit and power adaptor in a cool dry
place, out of the reach of children and pets.
Further Information
The screen resolution is 480x234 pixels. This is
a total resolution of 112,500 pixels (0.125MP).
High resolution pictures will slow loading
times without improving viewability.
After extended use, the frame may get warm.
This is normal and not a cause for concern.
Contrary to popular belief, if you leave a static
picture on the screen for a long time you may
leave a permanent ‘after image’ on the screen.
Slide show mode stops this from occurring.
Care and Cleaning
Care and cleaning operations should be carried
out with the unit unplugged from the mains.
Clean the plastic parts with a barely damp
cloth and then dry carefully.
Do NOT touch the screen with bare fi ngers, hard
or pointed objects. Clean the screen carefully
with a special cloth, such as a Calotherm cloth
available from chemists and opticians.
Warranty
Your Technika appliance is covered by a
warranty for 12 months from the date of
purchase. If a fault develops during this period,
please contact the TESCO electrical help line
on 0845 456 6767. Please have your original
purchase receipt with you when you call. This
warranty in no way aff ects your consumer
rights.
Specifi cations
Power Supply:
DC 5V 1.0A
Power adaptor:
DC 5V1.0A/AC100-240V
0.18A
Screen Resolution: 480x234 pixels
Colours: 16M
USB Compliance: USB 1.1or higher
Memory Card:
SD/MMC/MS
Weight: 381
grams
UK: Waste electrical products
should not be disposed of with
household waste. Separate
disposal facilities exist, for your
nearest facilities see www.recycle-more.co.uk
or in-store for details.
ROI: Produced after 13th August 2005. Waste
electrical products should not be disposed of
with household waste. Please recycle where
facilities exist. Check with your Local Authority
or retailer for recycling advice.