PDF User Manual

  1. Home
  2. Manuals
  3. Lexmark 20T3600 - T 620 B/W Laser Printer Quick Reference

Lexmark 20T3600 - T 620 B/W Laser Printer Quick Reference

20T3650 - T 620n B/W Laser Printer 20T3700 - T 620in B/W Laser Printer T620 T622 Monochrome Laser

Made by: Lexmark
Type: Quick Reference
Category: Printer
Pages: 1
Size: 0.16 MB

 

Download PDF User Manual



Full Text Searchable PDF User Manual



background image

Lexmark™ T620 and T622
StapleSmart™ Finisher
Quick Reference

Attaching the stacking paper bail

1

Lift the finisher output bin cover until it locks into position.

2

Snap

 the two paper bail posts into the slots under the output 

bin cover.

Adjusting the stacking paper bail

Slide the end of the paper bail in or out until the paper size for your 
print job is aligned with the arrow.

Using the paper bail hook

The paper bail hook prevents individual sheets in the output bin 
from sliding forward when a large stapled or offset job is pushed 
into the output bin. To use the paper bail hook, adjust the paper 
bail to the longest paper size in your printer and rotate the hook 
from the storage position. When not using the paper bail hook, 

snap

 it back into the storage position. 

Clearing staple jams

281

 (or 282) 

Staple Jam

Check Stapler

1

Lift the finisher output bin cover until it locks into position.

2

Remove the stack of paper.

3

Continue with step 1 in the 

283 Staple Jam

 section (for 

282 Staple Jam

 only).

283 Staple Jam

Check Stapler

1

Press the latch to open the stapler access door.

2

Firmly pull the colored tab to remove the staple cartridge 
holder from the stapler.

3

Orient the cartridge holder as shown in the illustration in 
step 4.

4

Use the metal tab to lift the staple guard, and then pull out the 
sheet of staples. 

Discard the entire sheet.

5

Remove any loose staples inside the staple guard.

6

Look through the clear covering on the bottom of the 
cartridge holder to make sure no staples are jammed in the 
entry throat.

7

Press down on the staple guard until it 

snaps

 securely into 

place.

8

Push the cartridge holder firmly into the stapler until the 
cartridge holder 

clicks

 into place.

9

Close the stapler access door.

Priming Stapler

 appears on the operator panel display. 

Priming occurs automatically to ensure the stapler is 
functioning properly.

10

Close the finisher output bin cover.

Troubleshooting

If stapled print jobs do not bind together in a neat set, you may 
need to replace the paper alignment wheels.

To order replacement wheels with a maintenance kit, use part
number 99A2480. Refer to the 

Publications

 CD for more 

information on maintenance kits.

If you are in the U.S. or Canada, call 1-800-438-2468 for 
information about Lexmark authorized supplies dealers in your 
area, or visit the Lexmark Web site at 

www.lexmark.com

. In other 

countries, contact the place where you bought your printer.

Paper bail 
hook

Staple cartridge holder

Stapler

Staple guard

E.C. 1K1255

P/N 11K3892

Copyright © 2001 Lexmark International, Inc. All rights reserved.

Printed in U.S.A.

This document is printed on recycled paper. 

2

/01