PDF User Manual

INSTALLATION AND OPERATION

M A N u A L

Thank you for buying Geyser water filter!

Our developments and technologies make it possible to ensure the excellent water quality 

in your house.

This manual describes all of the functions and installation procedure of Geyser water 

filtering system. Please carefully read and keep it for future use.

The  water  filter  set  includes  all  required  parts  to  use  the  system  immediately  after 

installation.

CONFIRMED BY TESTS:

Anti-plague station medical unit No. 164 of Federal medico-biological Agency of Russia 

(accredited testing laboratory center Rostest)
FSBI “SRI of Influenza” Ministry of healthcare of Russia
FSBI ECH and STATE them. Sysina, The Health Ministry of Russia

TECHNICAL CHARACTERISTICS OF 

GEYSER-ECO FILTERS

Cartridge

Aragon 3 Eco

Temperature of filtered water: °С

+4...+40

Maximum operating pressure, atm

7

Capacity, l/min

up to 3,6

Housing material

stainless steel

Height/diameter, mm

225/171

Cartridge service life*, l

up to 12000

* The actual service life depends on contamination degree of the source water

FILTERING EFFECTIVENESS OF 

ARAGON-3 ECO FILTER

Particles of > 0.1 µm in size 

up to 99%

Lead, zinc, cadmium, cesium

up to 95%

Chlorine

up to 100%

Pesticides

up to 92%

Iron

up to 95%

Aluminium

up to 97%

Oil products

up to 90%

SCOpO OF SuppLY 

1. Filter with installed Aragon-3 ECO Cartridge ...............................................................1 pc 

2. Clean water faucet .........................................................................................................1 pc 

3. Connector pipe, 1/4” JG .................................................................................................1 pc

4. T-piece adaptor with tap  ...............................................................................................1 pc.

5. Operation Manual  ..........................................................................................................1 pc

6. Packaging .......................................................................................................................1 pc

puRpOSE

The  Geyser  Eco  filter  is  designed  for  purification  of  the  tap  water  from  chlorine,  organic 

and organochlorine substances, heavy metals, iron, petroleum, mechanical particles and other 

undesirable impurities. It reduces the content of hardness salts.

The  compact  filter  Geyer  Eco  includes  all  the  traditional  methods  of  water  treatment: 

mechanical filtration, ion exchange, sorption, iron removal and disinfection.

The  filter  is  equipped  with  composite  cartridge  Aragon  3  ECO,  which  combines  unique 

properties of Aragon material and high quality coconut carbon (carbon block); this leads to 

increase of sorption purification capacity from chlorine and organic matter. Despite its compact 

size, Aragon-3 Eco provides high resource high efficiency of water purification

FEATuRES & BENEFITS

RELIABLE AND ECO-FRIENDLY STAINLESS STEEL HOuSING

The housing is tested at pressure of 25 atm.
Clamp connection provides tightness and easy cartridge replacement.
Stainless steel housing guarantees reliability and durability.

IT IS EASY TO INSTALL AND MAINTAIN

Everything  you  need  to  connect  the  filter  is  included  in  the  delivery  set.  Cartridge 

replacement is made without special tools or arrangements.

COMpACT

The filter takes 3 times less space than a conventional three-stage filter.

INSTALLATION OF THE CLEAN WATER TAp

Drill a 12 mm diameter hole in the sink. 
Assemble the water tap in the following sequence:
faucet
decorative washer
rubber gasket
rubber washer
plastic washer
split washer
metal nut

3

1

А

2

В

!

FILTER INSTALLATION

It is recommended to install the filter with assistance of a qualified expert or a representative 

of the manufacturer.

Do not disassemble the equipment without need.

PLEASE NOTE! Before you begin work, shut off the water supply and reduce the pressure 

by opening any faucet below the shut-off position.

SETTING up THE FILTER

The system is attached to the cold water main. 
Take  out  the  filter  from  the  packaging.  Remove  transport 

plugs.  Press  the  end  of  the  screwdriver  on  the  plastic  ring  in 

the connector and pull out the plug. Cut the pipe provided in the 

set into two parts, and attach each of the parts to the “in” and 

“out” nozzles of the filter (fig. 1). Place the filter in the location 

convenient for further operation. To make cartridge replacement 

more convenient, leave a 15 cm clearance between the floor and 

the bottom of the filter body. 

CONNECTION TO THE WATER SuppLY LINE

Make sure that the water supply line is shut off!
1.   Install the adapter T-piece (A) on the cold water main, and 

seal the junctions (fig. 1)

2.   Insert the plastic pipe into the nut (B) Install the pipe fully into the nozzle of the ball valve and 

tighten the nut (fig. 3)

1

PLEASE NOTE! Tighten the collar clamp if there should be any leakage from under the 

lid of the body.

Secure the faucet on the sink. Pass through the blue-color tube into nut (Е) (Fig. 1). Insert 

piston (Z) inside the tube as far as it will go. Put plastic stop ring (L) onto the tube end (Fig. 2). 

Screw the nut onto the threaded faucet rod (Fig. 3).

3

2

L

1

Е

Z

REpLACING CARTRIDGES

Cut off the water supply to the filter. Open clear water faucet. Disconnect the tube from filter. 

Loose the clamp connection (Fig. 1) open the clamp and detach the cover from the housing (Fig. 2).

Remove the cartridge (Fig. 3). Remove the plug from the bottom part of the cartridge and 

put it at the new one. Install new cartridge and put it at the filter cap. Lubricate the o-ring with 

silicone grease (not sealant!) or vaseline.

Insert the cartridge with the cap into the housing and latch the clamp. Screw the clamp 

connections. Supply water to the filter and make sure that there is no leakage in all connections, 

rectify if required. Let the water run through the filter for 2 minutes.

1

2

3

Before starting to use the filter, wash it through for 2-5 minutes. Wash the filter through after 

replacing the cartridge and after a lengthy interruption in use (more than 5 days). There’s air left 

in the system after the installation of the new filter or after replacing the cartridge. This leads to 

excessive water aeration (visually the water appears to be of milky white color). As the filter is 

used, the air will leave the system and the cleaned water will become transparent.

WARRANTY CERTIFICATE 

Release date

FILLED BY A VENDOR 
Date of sale

Vendor stamp 

ATTENTION! In case of do-it-yourself connection, the manufacturer bears no 

responsibility and accepts no claims resulted from the incorrect connection.

REpRESENTATIVE OFFICES

pRECAuTIONS DuRING TRANSpORATION AND STORAGE

Prevent the filter from falling, freezing and hitting. The filter can be transported in any enclosed 

transport  (except  non-heated  plane  compartments),  in  accordance  with  corresponding  mode  of 

transportation norms and rules. 

The filter must be stored in full packaging at least 1 meter away from any heating devices at the 

temperature from +5 to 25°С.

Keep away from aerosols, aggressive and fragrant substances.

WARRANTY

This filter is under warranty for three years since the date of sale; the clean water tap is under warranty 

for 1 year. If there should be no date of sale and stamp of the retail organization in the warranty brochure, 

its warranty period shall be calculated from the manufacturing date. This warranty shall not apply to 

the cartridge, the service life of the cartridge is shown in Table 1. If any manufacturing defects should 

be discovered in the cartridge, it can only be replaced after the service unit representative inspects it.

The manufacturer shall not be responsible for any operating problems or consequences of using 

the filter if: 

  the filter or its parts has mechanical damages;

  the setup and maintenance operations did not follow the instructions as set forth herein; the 

cartridge is beyond its resource life;

  the filter was not used for its intended purpose (to filter aggressive liquids).

The service life of filters is 10 years. Maintenance and post-warranty repairs are carried out by the 

manufacturer of their regional representatives.

Manufactured in accordance with TU 3697-023-48981941-2014

MANuFACTuRER: “AKVATORIA” LTD

Registered address:

69 Shosse Revolyutsii, build. 6, lit. A, 

Saint Petersburg, Russia 195279

Telephone/Fax: +7 (812) 605-00-55 (multichannel) 

Postal address:

195279, St. Petersburg, p/o box 379 
e-mail: office@geizer.com 

GEYSER D.O.O.

Južni Bulevar 136

111 18 Belgrade, Srbija

Phone: +381 141 744 20 77
e-mail: serbia@geizer.com

TIRAIS uDENS SIA

Salamandras iela 1, Riga, LV-1024 Latvia

Phone: +371 675-653-00
e-mail: ofiss@geizer.com

GEYSER FILTRY. S R.O.

Sokolovská 1276 / 152

180 00 PRAHA 8, Сeská republika

Phone: +420 222 368 239
e-mail: office@geyser.cz

www.geyser.pro

www.geizer.eu
www.geizer.com