Full Text Searchable PDF User Manual
Multi-Languages QIG in Driver CD
vodce rychlou instalací naleznete na
iloženém CD s ovlada
Auf der beiliegend Treiber CD finden Sie deutsche
Incluido en el CD el QIG en Español
Veuillez trouver l’français QIG ci-joint dans le CD
Incluso nel CD il QIG in Italiano
A magyar telepítési útmutató megtalálható a mellékelt
De nederlandse QIG treft u aan op de bijgesloten
Skrócona instrukcja instalacji w j
zyku polskim znajduje
Incluído no CD o QIG em Portugues
Cd-ul cuprinde Ghid de instalare rapida in limba
Anglického sprievodcu rýchlou inštaláciou nájdete na
priloženom CD s ovláda
: Ürün ile beraber gelen CD içinde Türkçe H
by Edimax Technology Co, LTD. all rights reserved. No part of
this publication may be reproduced, transmitted, transcribed, stored in a
retrieval system, or translated into any language or computer language, in
any form or by any means, electronic, mechanical, magnetic, optical,
chemical, manual or otherwise, without the prior written permission of this
This company makes no representations or warranties, either expressed or
implied, with respect to the contents hereof and specifically disclaims any
warranties, merchantability or fitness for any particular purpose. Any
software described in this manual is sold or licensed "as is". Should the
programs prove defective following their purchase, the buyer (and not this
company, its distributor, or its dealer) assumes the entire cost of all
necessary servicing, repair, and any incidental or consequential damages
resulting from any defect in the software. Further, this company reserves
the right to revise this publication and to make changes from time to time in
the contents hereof without obligation to notify any person of such revision
The product you have purchased and the setup screen may appear slightly
different from those shown in this QIG. For more detailed information about
this product, please refer to the User's Manual on the CD-ROM. The
software and specifications are subject to change without notice. Please
visit our web site
for the update. All right reserved
including all brand and product names mentioned in this manual are
trademarks and/or registered trademarks of their respective holders.
1. Product Information
Complies with wireless 802.11b/g/n standards
Increases Wireless coverage 4 times further *
Includes multi-language setup wizard
Supports USB 2.0/1.1 interface
Supports WMM, WMM-PS (IEEE 802.11e QoS standard)
Supports 64/128-bit WEP, WPA (TKIP with IEEE 802.1x),WPA2 (AES
with IEEE 802.1x) for high security level
Supports operating system: Windows 2000/XP/Vista, MAC 10.4.x and
above & Linux
* Maximum performance may vary depending on network conditions and
2. Package Contents
Before you starting to use this wireless network card, please check if
there's anything missing in the package, and contact your dealer of
purchase to claim for missing items:
Quick Installation Guide x1
CD (Wizard / Utility, Multi-language Quick Installation Guide & User
3. Network Card Installation
Please follow the following instructions to install your new USB wireless
1. Insert the USB wireless network card into an empty USB 2.0 port of your
computer when computer is switched on.
Never use force to insert the card, if you feel it’s stuck, flip the
card over and try again.
2. The following message will appear on your computer, click ‘Cancel’.
This wizard can be run in Windows 2000/XP/Vista.
procedures are operated in Windows XP.
You can install the Wireless Adapter by Setup Wizard in the CD-ROM
including in the package. The wizard is an easy and quick configuration tool
for internet connection with series process. When you start Setup Wizard,
you will get the following welcome screen. Please choose the language to
start the configuration. The wizard will guide you to finish your network
connection. We will not provide any instruction for the Setup Wizard here.
For advanced settings and other features of this wireless network
card, please refer to user manual enclosed in supplied CD-ROM.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experienced radio technician for help.
This device and its antenna must not be co-located or operating in conjunction with any
other antenna or transmitter. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance could void
the authority to operate equipment.
Federal Communication Commission (FCC) Radiation Exposure
This equipment complies with FCC radiation exposure set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches)
during normal operation.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
R&TTE Compliance Statement
This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF THE
EUROPEAN PARLIAMENT AND THE COUNCIL of March 9, 1999 on radio equipment
and telecommunication terminal Equipment and the mutual recognition of their
The R&TTE Directive repeals and replaces in the directive 98/13/EEC
(Telecommunications Terminal Equipment and Satellite Earth Station Equipment) As of
April 8, 2000.
This equipment is designed with the utmost care for the safety of those who install and
use it. However, special attention must be paid to the dangers of electric shock and
static electricity when working with electrical equipment. All guidelines of this and of the
computer manufacture must therefore be allowed at all times to ensure the safe use of
EU Countries Intended for Use
The ETSI version of this device is intended for home and office use in Austria, Belgium,
Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, Bulgaria,
Cyprus, Czech Republic, Estonia, Hungary, Latvia, Lithuania, Malta, Poland, Romania,
Slovakia, Slovenia, the Netherlands, Portugal, Spain, Sweden, and the United Kingdom.
The ETSI version of this device is also authorized for use in EFTA member states:
Iceland, Liechtenstein, Norway, and Switzerland.
EU Countries not intended for use
Please check the declaration of conformity on