Full Text Searchable PDF User Manual
MaxFighter Force Feedback F-33 Joystick User’s Guide
FEDERAL COMMUNICATIONS COMMISSION
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:(1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection. This equipment generates,
uses and can radiated radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables (except Output power cord) must be used in
order to comply with emission limits.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user‘s authority to operate the equipment.
Before you installation
Check your system must have the following:
IBM
TM
-Compatible PC, with Pentium
®
processor or faster
16MB RAM minimum
10MB hard-disk space
CD-ROM Drive
One dedicated USB port or 9 pin serial port
Windows
®
95/98
An installed mouse
Check you must have the following:
MaxFighter Force Feedback F-33 Joystick
Genius Force Feedback Game Device Software CD
Install the MaxFighter Force Feedback F-33 Joystick software
1.
Do not connect the MaxFighter Force Feedback F-33 Joystick to your computer
until after you have installed the Genius Force Feedback Game Device Software.
2.
With your computer running, insert the Genius Force Feedback Game Device
Software CD into the CD-ROM drive of your computer.
3.
Click
Start
, point to
Settings
, and then click
Control Panel
.
4.
Double-click
Add New Hardware
.
5.
Click
Next
.
6.
Click
Next
.
7.
Click
Next
.
8.
Choose
No
, and then click
Next
.
9.
Select
Sound, video and game controllers
, and then click
Next
.
10.
Click
Have Disk
.
11.
Type
D:\
and press the
Enter
key, where “
D
:” is the drive designation of your
CD-ROM drive.
12.
Select
iForce Gaming Device
, and then click
OK
.
13.
Click
Finish
.
14.
Click
Yes
to restart your computer.
15.
After your computer restart, the
Control Panel
should still appear on screen.
Double-click
Game Controllers
.
16.
Click
Add
.
17.
Select
iForce Gaming Device
, and then click
OK
to complete software
installation.
More about the Genius Force Feedback Game Device Software
1.
Make sure to install the Genius Force Feedback Game Device Software first, then
shut down your computer.
2.
Connect the MaxFighter Force Feedback F-33 Joystick to your computer, and restart
your computer.
3.
Click
Start
, point to
Settings
, and then click
Control Panel
.
4.
Double-click
Game Controllers
.
5.
Click
Properties
.
6.
On the
Test Input
tab, you can test all function on your game device.
7.
On the
Test Force
tab, you can play each default force effects.
8.
On the
Gain Settings
tab, you can set the force levels.
9.
On the
Help
tab, you can get more information.