PDF User Manual

  1. Home
  2. Manuals
  3. Exotic Flames Natural Gas Fire Pit Installation And Operating Manual

Exotic Flames Natural Gas Fire Pit Installation And Operating Manual

Made by: Exotic Flames
Type: Installation And Operating Guide
Category: Outdoor Fireplace
Pages: 3
Size: 0.15 MB

 

Download PDF User Manual



Full Text Searchable PDF User Manual



background image

 

F

IRE 

P

IT 

I

NSTALLATION AND 

O

PERATION 

G

UIDE FOR

 

 

Featuring Aquatic Glassel

®

 Tempered, Formulated Glass, 

©

2005 - 2007 

 

NATURAL GAS INSTRUCTIONS 

 

Adequate Fire Pit Ventilation is Required (if indoors) 

NOTE: 

READ INSTRUCTIONS FULLY BEFORE INSTALLING OR OPERATING.  

INSTALLERS, LEAVE THESE INSTRUCTIONS WITH THE CONSUMER! 

 
This product must be burned only in a fully vented (if indoors), non-combustible fire pit with the damper 
completely open (if indoors) and the chimney free of any obstructions or restrictions.  The fire pit must be 
designed and approved to burn wood.  The minimum permanent, free opening in the fireplace chimney 
must be 8 inches in diameter (50 sq. inches) or greater (for indoor installations). 
 

IT IS THE HOMEOWNER’S RESPONSIBILITY TO ASSURE THAT 

THEIR FIRE PIT HAS ADEQUATE DRAFT (for indoor installation only). 

 

WARNING:  IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A 

FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY 

OR LOSS OF LIFE. 

 

FOR YOUR SAFETY – IF YOU SMELL GAS 

1. OPEN 

WINDOWS 

2. 

DON’T TOUCH ELECTRICAL SWITCHES 

3. 

EXTINQUISH ANY OPEN FLAMES 

4. 

IMMEDIATELY CALL YOUR GAS SUPPLIER 

 
FLAMMABLE VAPORS MAY BE DRAWN BY AIR CURRENTS FROM OTHER AREAS OF 
YOUR HOUSE TO THIS APPLIANCE. 

 

GENERAL INFORMATION 

 
DO NOT USE A NATURAL GAS BURNER FOR PROPANE OR A PROPANE BURNER FOR NATURAL 
GAS.  WHEN USING PROPANE GAS (LPG) AN AUTOMATIC PILOT SYSTEM MUST BE INSTALLED. 
 

1. 

There are many different local codes for gas fireplaces.  The installation of Aquatic Glassel 
glass must conform to your local codes, or in the absence of local codes, conform to the 
National Fuel Gas Code (ANSI Z223.1 1999). 

2. 

Periodically, the glass may be dusted with a soft feather duster.  The top layer may also be 
scooped up and taken to a water source and washed. 

3. 

Do not burn wood with this product. 

 
NOTE:  

THIS PRODUCT MUST BE INSTALLED BY PERSONNEL QUALIFIED TO INSTALL GAS 

APPLIANCES, IF REQUIRED BY YOUR LOCAL CODES.  EXOTIC FLAMES BEARS NO 
RESPONSIBILITY FOR YOUR ACTIONS. 
 

Page 1 of 3 

 


background image

 

Step 1 

 
Clean out your fire pit (Figure 1).  
Remove old burner (unless it can be 
re-used). 
Attach your new burner with the flex 
line provided.  Hint – unscrew the fitting 
on each end of the flex line.  Screw the 
fittings to the burner and gas line first.  
Then screw the flex line to each fitting.  
Position the burner to the center and 2 
to 3 inches below the rim of the pit by 
gently bending the flex line. 
 

 
 

Figure 1 

 

Step 2 

 
Now pour in the crushed lava rock 
(Figure 2) while holding the burner in 
position. 
Pour in just enough lava rock to create 
a flat surface about an inch below the 
burner. 
Then switch to finely crushed lava rock 
(pea size), filling until the lava rock is 
flush with the top of the burner.  Also 
See Figure 4. 
 
 
 
 
 
 
 
 

Figure 2 

 
 
 
 
 
 
 
 
 
 
 
 
 
 

Page 2 of 3 

 


background image

 

Step 3 

 
Now pour and shape 2 inches of glass 
fill.  (Figure 3 and 4)  Your installation 
is now complete.  Turn on the glass 
and light the fire pit with a long lighter, 
making sure to keep your hand away 
from the surface of the glass.  Enjoy 
your product and thank you for 
purchasing from Exotic Flames! 
 

 
 
 
 
 
 
 
 

Figure 3 

 
 

 

 

Figure 4 

Page 3 of 3