Full Text Searchable PDF User Manual
Bicycle / Motorcycle Handlebar Mount & Water-Resistant Mobile Phone Holder
The Mobile Mounting Specialists™
Monday - Friday 9 am - 5 pm, PST
Arcadia, CA 91006 USA
Designed in USA | Made in China
© Copyright 2010 Arkon Resources, Inc.
(1) GN032-SBH - Bicycle or motorcycle handlebar mount with
swivel tightening ring
(1) SM-WPCS-WS - Water-resistant mobile phone holder with
Do not reposition the pedestal while cycling or driving. Arkon
Resources, Inc. does not promote the adjustment of mobile devices
except when the bicycle or vehicle is safely parked or stopped.
Arkon is not responsible for any damages caused to your bicycle, your
device, or yourself due to the installation or use of this product.
Mobile Phone Holder
Bicycle or Motorcycle
Snap the dual-T head adapter plate
onto the handlebar
. Adjust the angle as needed and screw the
ring onto the adapter plate until
the plate is securely held in place.
Connect the dual T-tabs
on dual T-tab adapter head to the
on the water-resistant mobile phone holder.
Insert the set screw
into the set screw hole
and screw in
tightly to prevent the pedestal head from slipping off .
Connect Water-resistant Mobile Phone Holder to Pedestal
A set screw has been provided to be installed into
the back side of the water resistant holder to secure it to the
handlebar pedestal. Ensure that the screw is properly installed
to prevent the holder from falling from the pedestal.
Fits handlebars up to 33mm diameter. Compatible with most straight, drop, trekking,
touring, and standard (25.4mm and 26mm) size handlebars. Also for use with golf carts,
ATVs, snowmobiles, hang gliders or other apparatus having cylinder-shaped frames or posts.
Choose a safe location on the handlebars of your bicycle
in which to mount the pedestal.
Using a screwdriver, remove the two mounting screws
in order to release the ball plate and swivel head
mount can be placed around the handlebars. Ensure the
are not lost when loosening the screws.
Bicycle Handlebar Mounting
Wrap the rubber rings
around the handlebar and reas-
semble the ball plate and swivel head
around the rubber
rings. Secure the mount assembly by using the screwdriver
to retighten the two mounting screws into the screw nuts
through the screw holes.