PDF User Manual

USER GUIDE

SOUNDBRICK 

Wireless speaker

3S-0951

IMPORTANT SAFETY INFORMATION

Read the following recommendations before using the 

SoundBrick Wireless Speaker:
•  Before recharging the SoundBrick through a wall outlet, 

make sure wall charger outlet voltage is 5V 1A;

•  Make sure to use the Micro USB Charge Cable that came 

with this product, other cables may damage your 

SoundBrick;

•  Do not drop, knock, disassemble or attempt to repair the 

SoundBrick. Do not immerse or put the SoundBrick in 

water. Store the SoundBrick in a dry place;

•  Do not expose the SoundBrick to excessive heat including 

direct sunlight and fire;

•  Do not use the SoundBrick near explosive gases or 

flammable materials;

•  Do not burn or incinerate the SoundBrick;
•  Do not expose the SoundBrick to harsh chemicals;
•  Keep the SoundBrick away from young children;
•  Putting anything in the SoundBrick’s input or output ports 

other than the supplied Micro USB Charge Cable or your 

device’s charging cable will cause damage or short out the 

SoundBrick;

•  To extend the SoundBrick’s charging life, do a complete 

recharge of the SoundBrick every four months;

PLEASE NOTE: The SoundBrick is only WATER 

RESISTANT. It has a level 6 water ingression rating that 

means it can sustain high pressure water jets for 30 

minutes. It cannot be fully submerged in water.

3

Welcome

This User Guide will give you the 

information on how to enjoy your 

3SIXT SoundBrick Wireless Speaker.

For more information and support, 

visit 

www.3sixtgear.com

4

1

2

3

4

5

10

6

8

9

7

Front

Side

Side

Back

Top

Base

GETTING TO KNOW YOUR SOUNDBRICK 

WIRELESS SPEAKER

Buttons, Ports & Lights
1- Power Button
2- Volume/Track (-)
3- Multi Function Button
4- Volume/Track (+)
5- Indicator Light

6- Micro USB Port
7- AUX Port
8- Dust Cover
9- Wrist Strap Hook
10- Mounting Screw

5

4

ACCESSORIES

1)  SoundBrick Wireless Speaker
2)  Micro USB Charge Cable
3)  3.5mm AUX Cable
4)  User Guide

HIGHLIGHTS

The 3SIXT SoundBrick Wireless Speaker can be connected 
to Bluetooth® devices such as smart phones, tablets and 
computers to playback your favourite music via streaming 
services or through your own music library. Thanks to the 
powerful speakers and passive woofer system the SoundBrick 
delivers crisp full stereo sound. The SoundBrick can sustain up 
to 8 hours of continuous usage. The SoundBrick is the perfect 
companion for you to use, in the park, while camping, at the 
beach...anywhere!

WIRELESS CONNECTION

Turn the SoundBrick on by pressing the power button for 
several seconds, then the blue LED (5) will illuminate and a 
tone will be heard.

CONNECT TO MOBILE PHONES/TABLETS/COMPUTERS

Activating Bluetooth® on your device:
1)  Go to your device Bluetooth® settings and scan for new 

Bluetooth® devices;

2)  Search for 3SIXT 3S-0951 and once found, click on it to 

pair with the SoundBrick;

6

3)  If your device asks for a pairing code, please enter ‘0000’ 

and confirm it.

4)  After successful pairing, the SoundBrick will make a sound 

and the LED light (5) stays blue.

Note: Pairing time varies with different devices. The SoundBrick 
only needs to be paired the first time and it will automatically 
connect when the device is back in range or is turned back on 
(the SoundBrick remembers the last 8 paired devices’ names).

AUX AUDIO-IN CONNECTOR

The SoundBrick also features 1 x AUX audio-in port (7). Simply 
connect the SoundBrick with your device via the 3.5mm jack 
audio cable. The green indicator light (5) will illuminate. Now 
you are ready to play music via the wired AUX connection.

LOW POWER INDICATOR

The SoundBrick will make a voice prompt to remind you to 
charge if the battery is low (battery <10%). You will need to 
charge the SoundBrick regularly to maintain a full charge.

CHARGING AND COMPUTER CONNECTION

Connect the Micro USB Charge Cable to a USB 5V 1A charger 
to recharge the SoundBrick’s internal battery via the Micro 
USB port (6). Whilst charging, the LED light will illuminate Red. 
Once Charging is complete the red LED light (5) will turn off. 
This indicates that the SoundBrick is fully charged and ready 
for use.

7

6

TECHNICAL SPECIFICATIONS

Audio input connector

3.5 mm

Ingress Rating

IPX6 Water Resistant

Battery

Lithium Ion 3.7v/1500mAh

Wireless Protocol

BT v4.1

Distance

Up to 10m

Input

5V 1A

Audio Output

5W Speaker x 2

Unit

40 mm x 2

Playback Time

Up to 8 hours

Recharge Time

5-6 hours

Dimensions

174.5 x 71 x 50mm

Weight

370g

Frequency Range

160Hz-20KHz

DistortionTHD

1%

Working Temperature

Temperature: 0°C - 40°C / Humidity: 0% -85%

Storage Temperature

Temperature: -30°C - 60° C / Humidity: 0% -90%

Please Note:

 We do our best to reflect accurate specifications, however 

periodic updates and changes may occur after this manual was printed. We 

reserve the right to change the parameters without prior notification.

8

GENERAL OPERATION

Powering On/Off

Long press the Power Key (1) to power on/off.

Answering a call

During an incoming call, short press the MF key 

(3) to answer the phone, short press again to 

end the call and return to music.

Ending or refusing a call

Short press ‘MF’ key (3) to end the call or long 

press ‘MF’ (3) to refuse the call.

Play/Pause

Short press ‘MF’ key (3) to adjust.

Volume - or +

Short press ‘+/-’ (4 & 2) to adjust.

Next/Previous

Long press ‘+’ (4) to go to the next track. Long 

press ‘-’ (2) to go to the previous track.

Disconnect wireless 

connection

Long press ‘+’ (4) and ‘-’ (2) to disconnect the 

current wireless connection. The SoundBrick 

will then start searching for a new device.

Please note: When in wireless mode if the 3.5mm AUX cable is inserted,  

the SoundBrick will switch to ‘line in’ status automatically.  

Please turn off the SoundBrick when not in use to prevent power drain.

LED STATUS

Wireless Status

Blue light (5) flashes

Pairing mode

Blue light (5) steady

Connected

Line in Mode

Green light (5) illuminates

Line in mode

Charging Status

Red light lluminates when connected to a power source

Red light (5) lluminates

Charging

9

8

TROUBLE SHOOTING

1.  My device can’t find any new Bluetooth® devices

a)  Make sure the SoundBrick has entered pairing mode.
b)  Ensure the SoundBrick is within the effective working 

range (10m).

2.  Bluetooth® devices cannot pair

a)  Make sure your device allows new Bluetooth® 

connections.

b)  Make sure the pairing password entered is ’0000’.  

If you are using a Bluetooth® transmitter device, 
please ensure the responding password of your 
Bluetooth transmitter supports the ‘0000’ code.

3.  My SoundBrick does not play music or answer calls 

when it is connected to a Bluetooth® device

a)  Make sure your Bluetooth® device supports A2DP 

and HSF profile.

b)  Ensure your Bluetooth® enabled device is within the 

effective working range.

4.  When paired with my computer, Windows asks for a 

new driver. Can you supply?

Sorry, we do not supply drivers. Please visit your PC 
manufacturer’s website for the latest driver updates.

5.  Is the SoundBrick waterproof?

No, the SoundBrick is only water resistant.  
It has a level 6 water ingression rating that means it can 
sustain high pressure water jets for 30 minutes. It cannot 
be fully submerged in water.

10

AUSTRALIA & NEW ZEALAND 
TWO YEAR WARRANTY

3SIXT will replace the faulty product at no cost to the consumer. 

The warranty does not extend to any consequential damages or 

costs that may be incurred and is valid for TWO YEARS from date 

of purchase. The consumer must return the faulty product to the 

retail store it was purchased from together with proof of purchase. 

The benefits to the consumer under this warranty are in addition 

to other rights and remedies of the consumer under Australian 

and New Zealand laws in relation to the goods to which the 

warranty relates. Our goods come with guarantees that cannot be 

excluded under the Australian Consumer Law. You are entitled to 

a replacement or refund for major failure and for compensation 

for any other reasonably foreseeable loss or damage. You are also 

entitled to have the goods repaired or replaced if the goods fail to 

be of acceptable quality and the failure does not amount to a 

major failure.
The warranty is provided by:
Australia: Cellnet Group Limited 

59-61 Qantas Dr, Eagle Farm, QLD 4009 

Phone: 1300 CELLNET (1300 235 563) 

Email: info@cellnet.com.au
New Zealand: Cellnet Limited 

10a Orbit Dr, Rosedale, Auckland 0632 

Phone: 0800 CELLNET (0800 235 563) 

Email: info@cellnet.co.nz

10

EN

DE

FR

ES

IT

3SIXT PRODUCT SUPPORT 

For more information, visit

 www.3sixtgear.com/support

3SIXT PRODUKT-SUPPORT 

Bitte besuchen Sie

 www.3sixtgear.com/support

ASSISTANCE PRODUIT 3SIXT 

Veuillez consulter

 www.3sixtgear.com/support

ASISTENCIA TÉCNICA DEL PRODUCTO 3SIXT 

Visite

 www.3sixtgear.com/support

ASSISTENZA TECNICA 3SIXT 

Si prega di visitare

 www.3sixtgear.com/support

Copyright © 2017.

3SIXT and its logo are trademarks of Cellnet Group Limited 

 in Australia & New Zealand. All Rights Reserved.

The Bluetooth® word mark is a registered trademark owned by Bluetooth SIG, Inc.

CELLNET GROUP LIMITED  

59-61 Qantas Drive, Eagle Farm, QLD 4009 Australia. 

MADE IN CHINA.

3SIXTgear.com

For more information, visit

www.3sixtgear.com

or visit

 www.3sixtgear.com/support

3SIXTgear

3S-0951