PDF User Manual

Tabel of Content

What’s in the Box 

01

Feature Introduction 

02

Setting Up the Camera and Monitor  03

Replacing the Camera lens 

11

Safety 12

Customer service 

15

01

02

What’s in the Box

Baby Camera 

(T8300-M)

Baby Monitor 

(T8300-C)

Camera Adapter 

(5V 2A)

Monitor Adapter 

(5V 2A)

Wall Mount

Wide-Angle Lens

Monitor Micro-USB 

Power Cable (1.5 m)

Camera Micro-USB 

Power Cable (3 m)

Mounting 

Screws

User manual

Feature Introduction

Monitor Features:

6

5

2

1

3

4

9

10

8

12

11

13

7

1

Volume controls

8

microSD card slot

2

Screen 

9

Support stand

3

Power button

10

Micro USB charging port

4

Menu button

11

LED indicator

5

Navigation buttons

12

Microphone

6

Return to previous level 

of menu / Talk button

13

Speaker

7

Monitor Antenna

Press and hold the Talk button to speak to the 

camera. When Menu is opened, press Talk button 

once to return to previous level of menu. 

Press Power button to switch on / off the monitor 

screen. Press and hold the Power button for 2 

seconds to switch on / off the monitor.

Power adapter varies by region. 

03

04

microSD memory card can only be used for firmware 

upgrade, it cannot be used to store video recordings.

Camera Features:

2

1

3

4

5

6

1

Standard camera lens

4

Speaker

2

Microphone

5

Micro USB port

3

Power LED Status  indicator

6

Pairing button

Setting Up the Camera and Monitor

Monitor Installation

Fully charge the monitor before use. To charge:

Connect the baby monitor to the monitor adapter with the Micro 

USB cable, and then connect the adapter to a power outlet. 

Connect the other end of the baby monitor’s Micro USB power 

cable to the Micro USB port in the monitor to charge it. Press and 

hold the power button for 2 seconds to turn the baby monitor on.

Camera Installation

Connect the baby camera’s Micro USB power cable to the camera 

adapter (5V 2A), and then connect the adapter to a power outlet. 

Finally, connect the other end of the baby camera’s micro USB 

power cable to the micro USB port in the camera. 

07

08

Press and hold the power button to power on the monitor. 

Press the menu button to open Menu Settings.

1

Monitor Menu Settings

Menu Options

Description

Available Options

Brightness

Set the brightness of the 

screen.

Use the navigation 

buttons to adjust 

the brightness level 

Sleep Mode

Select to turn off the 

screen after 1 min, 3 min, 

or 5 min.

Off / 1 min / 3 min 

/ 5 min 

Sound Alert

Sound Level

Note: You can set the 

baby monitor to alert you 

when a specific noise 

level is detected. 

Off / Level 1 / Level 

2 / Level 3 / Level 

4 / Level 5
Note: Level 1 has 

the best sensitivity. 

Alert Duration

10 Secs / 20 Secs / 

30 Secs / 60 Secs

Time

Set the time on the 

monitor.

Zoom 

Set the zoom level.

Off / 1.5x / 2x

Camera

Add Camera
Note: You can add up 

to 4 cameras per baby 

monitor.

Delete Camera

Delete / Cancel 

Cycle Cameras
Note: Cycles through the 

list of connected baby 

cameras according to 

preset intervals. 

Off / 5 Secs / 10 

Secs / 15 Secs / 30 

Secs

Night Vision 

Mode

When enabled, the camera 

will change the screen 

color accordingly to the 

light conditions in the 

room. When disabled, 

the camera will stick to 

daylight screen color and 

will not change when the 

surrounding environment 

is getting dark.

On / Off

Anti-Screen 

Flicker

Changes the refresh rate 

of the screen to prevent 

flickering.

Mode A / Mode B

12

11

Replacing the Camera lens

Lens type

Usage 

Lens

Standard camera 
lens (default lens)

This lens is 

recommended for 

general viewing; 

infants are clearly 

seen within a 2~3m 

range.
The lens angle of 

view for standard 

camera lens is 62°. 

Wide-angle lens

This lens provides a 

wide-angle view of 

the room. The lens 

angle of view for 

wide-angle lens is 

110°.

Back

Front

The standard camera lens is not removable. When you want 

to use the wide-angle lens, simply place it over the standard 

camera lens and fasten. 

Safety

Warning

Strangulation Hazard: Children have STRANGLED in cords. Keep this cord out 

of the reach of children (more than 1m (3ft) away). Never use extension cords 

with AC Adapters. Only use the AC Adapters provided. 

  This product complies with the radio interference requirements of 

the European Community.

Declaration of Conformity

Hereby, Anker Innovations Limited declares that this device is in compliance 

with the essential requirements and other relevant provisions of Directive 

2014/53/EU.For the declaration of conformity, visit the Web site https://

www.eufylife.com/.
This product can be used across EU member states.

Due to the used enclosure material, the product shall only be connected to a 

USB Interface of version 2.0 or higher. The connection to so called power USB 

is prohibited.

A statement regarding the AC/DC adapter as disconnect device is missing in 

the user manual.

The statement shall require a socket outlet that is installed near equipment 

and that shall be easily accessible.

The adapter shall be installed near the equipment and shall be easily 

accessible.

Do not use the Device in the environment at too high or too low temperature, 

never expose the Device under strong sunshine or too wet environment. 

The suitable temperature for the product and accessories is -20°C-60°C.
When charging, please place the device in an environment that has a normal 

room temperature and good ventilation. 

It is recommended to charge the device in an environment with a 

temperature that ranges from -10°C~40°C. 

Please ensure to use only the charger offered by the manufacturer. Using 

unauthorized charger may cause danger and violate the authorization of the 

projecter and the guarantee article.
The charger output voltage/current is 5Vdc/2A. The plug considered as 

14

13

disconnect device of adapter.

If you use a third-party charger, the recommended outputvoltage/current of 

the adaptor is 5Vdc/2A,and the adapter shall be CE approval type.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT 

TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS

RF exposure information: The Maximum Permissible Exposure (MPE) level 

has been calculated based on a distance of d=20 cm between the device and 

the human body. To maintain compliance with RF exposure requirement, use 

product that maintain a 20cm distance between the device and human body.

Operating Frequency Range: 2410-2477MHz 
CE SAR:
The SAR limit of Europe is 2.0 W/kg. Device types T8300-M has also been 

tested against this SAR limit. The highest SAR value reported under this 

standard. This device was tested for typical hand held operations with the 

back of the device kept 0mm from the Limb.

The following importer is the responsible party (contact for EU matters only)

Importer:Anker Technology (UK) Ltd

Importer Address:Suite B, Fairgate House, 205 Kings Road, Tyseley, 

Birmingham,United Kingdom B11 2AA
 

  This product is designed and manufactured with high quality 

materials and components, which can be recycled and reused. 

 This symbol means the product must not be discarded as household 

waste, and should be delivered to an appropriate collection facility for 

recycling. Proper disposal and recycling helps protect natural resources, 

human health and the environment. For more information on disposal and 

recycling of this product, contact your local municipality, disposal service, or 

the shop where you bought this product.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject 

to the following two conditions: (1) this device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

Warning:

 Changes or modifications not expressly approved by the party 

responsible for compliance could void the user's authority to operate the 

equipment.

Note: 

This equipment has been tested and found to comply with the limits 

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 

are designed to provide reasonable protection against harmful interference 

in a residential installation. 
This equipment generates uses and can radiate radio frequency energy and, if 

not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following measures: 

(1) Reorient or relocate the receiving antenna. (2) Increase the separation 

between the equipment and receiver. (3) Connect the equipment into an outlet 

on a circuit different from that to which the receiver is connected. (4) Consult 

the dealer or an experienced radio/TV technician for help. 
FCC Radio Frequency Exposure Statement
The T8300-C device has been evaluated to meet general RF exposure 

requirements. The T8300-C can be used in fixed exposure condition. The min 

separation distance is 20cm.

This T8300-M was tested for typical body‐worn operations with the back of 

the handset kept 0 mm from the body.

RF Exposure Information(SAR)

The Extremity SAR limit of FCC for Hand held is 4.0W/kg.

Device is recommended to use in hand held only and SAR when hand held is 

1.804W/kg
Worn on body will have unexpected RF exposure RISK.
The following importer is the responsible partyCompany Name: 

POWER MOBILE LIFE, LLC

Address: 400 108th Ave NE Ste 400, Bellevue, WA 98004-5541

Telephone:1-206-383-8247