PDF User Manual

Quick Instruction of WiFi Connection

Part 1 Appearance of SolarRiver inverter with WiFi

Note: Before unpacking, the antenna is fixed by plastic clips. When finished the installation of inverter, 
pull the antenna from the plastic clips lightly and make it vertical for getting better signal.

SAMIL POWER CO., LTD.
Add: No.6, Xuefengshan Road, Suqian High-tech Industrial Development Zone,
Jiangsu Province, P.R.China. 223800
Tel : +86 (0) 527 88754666
Fax: +86 (0) 527 84453877
E-mail: service@samilpower.com

Initial status

Work status

Initial status

Work status

SolarRiver 1100TL/1600TL 

SolarRiver 2300TL/3000TL 

01

Continue

Part 2 The procedure of WiFi setting 

Step 1: Write down the WiFi SSID of inverter.

When the inverter is running, press the function button until the WSN is displaying on the screen.

Record  the  numbers  on  the  display.  The  WiFi 
SSID  of  inverter  is  AP_XXX  XXX  XXX  which  is 
used later for connecting with PC or smart phone.

Step 2: Configure and set parameter of WiFi module.

(Prepare a laptop with WiFi and make sure the WiFi function is enable. Then follow the steps below to 
finish the WiFi connection.)

a) Open the wireless network connection.
b) Refresh the network list and choose 
    the WiFi SSID: AP_130 420 302.
c) Input the default password
    “WIFI 123456” in the popup window.
d) Connect it.

d) Input the website:
    http://10. 10. 100. 254 into the address 
    bar.

e) Enter the user name: admin.
f ) Enter the password: admin, click OK.

02

The server 10. 10. 100. 254 at USER LOGIN requires a
username and password.

Warning: This server is requesting that your username and
password be sent in an insecure manner (basic authentication
without a secure connection). 

User name:

Password:

Remember my password

http://10. 10. 100. 254/

Connect to 10. 10. 100. 254

AP_130 420 302

Wait about 30 seconds after successful setting, the inverter will show its IP address and the green LED at 
the bottom of the inverter will light at the same time:

1) Finish.

1) Click on the “Restart” button.

Restart

1) Select the language.
2) Go to the STA setting page.

System

中文

 l English

1) Click on the “Scan” button.

Scan

STA Setting

1) Select the correct WiFi SSID.
2) Click on the “OK” button.

OK

1) Input the password.
2) Click on the “Save” button.

Save

Password

03

Part 4 Reload the default WiFi setting

If  you  want  to  cancel  the  WIFI  setting  which  you  have  made  and  start  a  new  connection,  finish  the 
following steps and return to Part 2:

Step 1: Press the function button to the IP address page.

Step 2: In the IP address page, hold pressing the function button and release it until displaying “Reload”.

Step 3: Press the function button again. The display shows “Reload OK”. Then the inverter’s WiFi address 
has been reset successfully.

04

Part 3 How to change the WiFi SSID or password of the inverter

1) Visit the website:10.10.100.254 and login. (Refer to part 2)
2) Go to the AP Setting page.
3) Change the SSID or Password.
4) Click on the “Save” button.

Save the password setting

Save the SSID setting