Related Product Video
Full Text Searchable PDF User Manual
Rechargeable And Waterproof Remote Training
System With Auto And Manual Mode And Of 1000
For power saving purposes,the background light of the
remote will switch off automatically if there is no operation
for a short period of time and will come on after any button
is pressed.For convenience,the remote doesn
t have sleep
mode.If you want to turn off the remote ,you can press this
for a short time.
II. Getting started
Both the remote and collar are rechargeable,please charge
them before using them.But please do not overcharge them as it
may cause damage to them.
For both the remote and collar,a full charge takes
approximately 2 hours.
Charging the remote:
When charging is in progress,the
flashing battery icon will show you the level of the current
charge of the battery.When completed,the battery icon will stop
Charging the collar:
Station of LED Indicator on the
Red LED is flashing
Red but do not flashing
II-2 Configure Steps
Firstly ,open the remote.Press this button
for a short
Secondly, open the receiver.Press this button for a short
time.And you will hear a beep.
Thirdly,press this button
to pair,and you will hear a
,and you can see the
is flashing on the
screen.Then press this button
you will hear the beep and
the receiver is vibrating. Every time you launch vibration
channel you must press
. And you can press these button
to increase or decrease the intensity
The operation of shock is the same as above.
Beep function:you can press this button
can press this button
and then press this button
This system can be used for 1 or 2 receivers.
Automatic Mode:press this button
,and then press
.And you will hear the beep.You can adjust the
sensitivity,you must press
or your operation will be
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions (1)this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.